Burn live
WiSPDocs Open the app

Money in and out

Send and receive privately

Pay any Solana wallet address from your private balance, and take payments on one-time addresses that your recovery phrase can find again.

On this page

Send

  1. Open Shield and tap the Withdraw tab.
  2. On the Send privately card, paste the recipient's external Solana wallet address under To and type the Amount from private balance in SOL. That amount leaves your private balance; the recipient gets it less the pool provider's fee, and the sheet shows both.
  3. Tap Review send, check the address and the amounts on the sheet, and tap Approve and send.

The toast reads Sent privately with the signature.

The payment leaves the privacy pool, so the chain shows the pool paying the recipient, not your account. The pool provider charges 0.006 SOL plus 0.35%, read from the provider each time, and has a minimum amount it will pay out. WiSP refuses an address it derives for you, because paying one would link your own wallets: your funding address, a trading wallet this device knows (and the next 20), a refund wallet of a note it has read, and every receive address the account can ever hand out, on any device.

A payment cannot be recalled. Check the address on the sheet before you approve.

Receive

  1. Open Shield and tap the Shield tab.
  2. On the Receive card, tap New receive address and copy it.
  3. Give that address to whoever is paying you. Use a new one for each payment.
  4. When the row shows RECEIVED, tap Review shield and approve. Everything at the address moves into your private balance, down to zero.

The transfer from the payer to the receive address is public, and so is the shield from that address into the pool. What happens after the pool is not linked to it. The shield pays the network fee from the received SOL; an address needs a little over 0.0035 SOL before it can be shielded.

WiSP hands out a new address while fewer than 8 are open. A rebuild can bring back more than 8 that hold a payment; each stays collectable. A payment that arrives after an address was shielded shows again under Receive (WiSP rechecks the 200 addresses this account used most recently, ahead of ones it only found in chain history; Rebuild from phrase finds older ones), and can be shielded the same way.

On a new device

Receive addresses come from your recovery phrase, numbered in a way a rebuild can search: 16 numbered series, about 3,800 addresses in all for one account. After a restore, Keys → Rebuild from phrase reads the chain through your RPC for the receive addresses this account has used, on any device, and brings back a payment still waiting at one. A restore from the phrase does this once by itself; if the search cannot finish (the Receive card and Keys say so), the next rebuild continues from where it stopped and keeps what it already found. It relies on your RPC keeping each address's full history, as WiSP's default RPC does. An RPC that reports history that isn't there can make WiSP treat unused addresses as used and run out of new ones; the card then says so, and your funding address still takes payments.

Two devices of one account each hand out their own addresses. Rarely, both can hand out the same unpaid address; then the two payers can see each other's payment on chain. Nothing is lost.

What is public

PublicNot linked
Sendthe pool → the recipient, and the amountyour account
Receivethe payer → your receive address → the poolwhere the money goes after the pool

Last checked against the app: 12 November 2026, build 82bd20d